Show product


Pneumatic Measuring Pneumatic Measuring Device

The pneumatic measuring can be used in many areas of industrial production. The method and technique of pneumatic measurement is particularly characterized by the very high accuracy of 1.0 micron and very good stable Wiederholfähigkeit of 0.1 microns in a very short time. The Unaffected by the environment (dirt / temperature) makes it unnecessary to clean the parts to be measured to achieve with this method, a good reproducibility of the results.


Pneumatic measuring The pneumatic measuring is a non-contact measurement that protects the parts to be measured. Typical applications are measurements of diameter, length measurement between axes, measuring cone, eccentricity, pairing measurement etc are typical applications of this type of measurement.

Grinding machines


A pneumatic measuring ring may be positioned directly under the grinding stones, and the part can be inserted to check control, with a tolerance of the order of one tenth of micron. This measuring device can also be installed on older machines.


Diameters from 0.01 mm


Said pneumatic measuring system enables the control small holes and bores run, whose diameter may be mm under certain conditions, in the smallest 0.01. The dies are controlled by these systems to determine the inner diameter.


For the industry of wire drawing, it is ideally suited.

Upfor AB

Regattagatan 8A
SE-723 48 Västerås
Phone: +46 (0) 21 150 160
© 2012 Upfor AB
Made by Northware